Filter
Top Products
15
(E)42DPC85
Connecting
your Monitor
Using the
remote control
Setting up
your Monitor
Appendix
Index
Introduction
Operating
your Monitor
[1]
HDMI = High-Definition Multimedia Interface.
[2]
DVI = Digital Video Interface.
[3]
HDCP = High-bandwidth Digital Content Protection.
[4]
EIA/CEA-861/861B compliance covers the transmission of
uncompressed digital video with high-bandwidth digital
content protection, which is being standardized for reception
of high-definition video signals. Because this is an
evolving technology, it is possible that some
devices may not operate properly with the monitor.
Connecting an HDMI
TM
or a DVI device to the HDMI input
Monitor
HDMI device
HDMI, the HDMI logo, and High-Definition Multimedia Interface are
trademarks or registered trademarks of HDMI Licensing, LLC.
The HDMI
[1]
input on your monitor receives digital
audio and uncompressed digital video from an HDMI
device or uncompressed digital video from a DVI
[2]
device.
This input is designed to accept HDCP
[3]
program
material in digital form from EIA/CEA-861/861B–
compliant
[4]
consumer electronic devices (such as a set-
top box or DVD player with HDMI or DVI output).
The HDMI input is designed for best performance
with 1080i high-definition video signals, but will also
accept and display 480i, 480p, and 720p signals.
VIDEO AUDIO
LR
IN
OUT
HDMI OUT
To connect an HDMI device, you will need:
• one HDMI cable (type A connector)
For proper operation, it is recommended that you
use a short HDMI cable.
HDMI cable transfers both video and audio.
Separate analog audio cables are not required (see
illustration below). Some CDVs (video CDs) may
not output digital audio signals. In that case, you
may hear sound by connecting analog audio cables.
However, if you connect analog audio cables with
this connection, the HDMI terminal on the monitor
will not receive the HDMI digital audio signal and
you will hear analog audio only.
NOTE: NEVER CONNECT THIS
MONITOR TO A PERSONAL
COMPUTER (PC).
THIS MONITOR IS NOT INTENDED FOR USE
WITH A PC.
To ensure that the HDMI or DVI device is reset
properly, it is recommended that you follow these
procedures:
•When turning on your electronic components, turn
on the monitor first, and then the HDMI or DVI
device.
•When turning off your electronic components, turn
off the HDMI or DVI device first, and then
the monitor.
VIDEO AUDIO
LR
IN
OUT
DVI
OUT
To connect a DVI device, you will need:
• one HDMI-to-DVI adapter cable
(HDMI type A connector)
For proper operation, the length of the HDMI-to-DVI
adapter cable should not exceed 9.8 ft (3m). The
recommended length is 6.6 ft (2m).
• one pair of standard analog audio cables
An HDMI-to-DVI adapter cable transfers video only.
Separate analog audio cables are required (see
illustration below).
Monitor
DVI device
#01E09-15_42DPC85 7/29/05, 12:48 PM15
Black