Filter
Top Products
(E) 51/57/65H94
Copyright © 2004 TOSHIBA CORPORATION. All rights reserved.
40
Selecting the menu language
You can choose from three different languages (English, French
and Spanish) for the on-screen display of adjustment menus and
messages. (The TV Guide On Screen menus are in English,
regardless of the language selected in this menu.)
To select the menu language:
1. Press MENU and open the PREFERENCES menu.
2. Highlight MENU LANGUAGE and press ENTER.
3. Highlight your preferred menu language in the menu
sidebar and press ENTER.
4. Press EXIT to close the PREFERENCES menu.
Configuring the antenna input
sources
To configure the ANT 1 and ANT 2 input sources:
1. Press MENU and open the SETUP menu.
2. Highlight INSTALLATION and press ENTER. (A new set
of INSTALLATION menu icons will appear on-screen, as
shown in step 3 below.)
3. Open the TERRESTRIAL menu, highlight INPUT
CONFIGURATION, and press ENTER.
Note: The TERRESTRIAL menu may not be accessible
(items will be “grayed out”) in some instances (for example, if
a cable box is connected to the ANT 1 input or if one of the
VIDEO modes is the current input during TV Guide On
Screen setup).
Te rrestrial
Input Configuration
Channel program
Channel Add
/
Delete
Navigate Select Back Exit
DVD RTN
CH RTN
EXIT
Signal Meter
4. Press • to select the input source (Cable or antenna) for the
ANT 1 input on the TV.
Note: If a cable box is connected to the ANT 1 input during
TV Guide On Screen setup, the entire TERRESTRIAL menu
will not be accessible, including the input source for ANT 1,
which will automatically display “Cable Box.”
5. Press z and then • to select the input source (Cable or
antenna) for the ANT 2 input on the TV, if applicable. If
you have not connected anything to ANT 2, skip this step.
Save Cancel
Input Configuration
Antenna 1 In
Antenna 2 In
Cable
Antenna
6. To save your new settings: Highlight SAVE and press
ENTER.
To revert to your original settings: Highlight CANCEL
and press ENTER before saving.
Setting up your TV
6
For menu navigation instructions, see Chapter 4.
HM94(E)040-43(6a-Setup) 8/31/04, 2:03 PM40