Toshiba 52HMX95 Projection Television User Manual


 
81
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
(E) 52/62HMX95
Chapter 8: Using the TV’s features
Using the POP double-window feature
The POP (picture-out-picture) double-window feature splits the screen into two
windows so you can watch two programs at the same time.
To display a program in the POP window:
1. Select the program you want to watch in the main window.
2. Press SPLIT to open the POP double-window.
POPANT1
Video1
TV12
3. Press to highlight the POP (right) window. When highlighted, the window
will have a green border.
4. Press INPUT to open the POP Input Selection window. Select the input source
for the POP window by pressing the corresponding Number button (0–9). The
current source displays in purple in the POP Input Selection window.
ANT 1ANT 1
Video 1
Video 2
Video 3
ColorStream HD1
ColorStream HD2
HDMI 1
PC
ANT 2
- / to Select
INPUT
0
0
1
2
3
4
5
HDMI 2
6
7
8
9
9
POP Input Selection
To tune to the highlighted window (and close the POP window):
Press ENTER after highlighting the window you want to view as a normal
picture.
To close the POP window:
Press SPLIT or EXIT.
Notes about recording:
If the POP window is open and you attempt to start recording, the POP window will close before
recording starts.
If you use the TV’s remote control to start recording, you will not be able to open the POP window
and the message “Not Available” will appear on-screen if you try to do so.
It is recommended that you use the TV’s remote control to start recording. If you use a device other
than the TV’s remote control to start recording, you may be able to open the POP window during
the recording process. If this happens, the recorded audio will reflect the audio of the active window
(main or POP), which may not be the audio you intended to record.
SPLIT
Main window
POP window
Using the POP features
Numbers
INPUT
Green border
(denotes active window)
Note:
When the main window is in ANT1 or ANT2 mode,
the ANT1 and ANT2 inputs cannot be selected for
the POP window.
When the main window is in Video 1, Video 2,
Video 3, ColorStream HD1, ColorStream HD2,
HDMI 1, or HDMI 2 mode, that same input
cannot be selected for the POP window.
You cannot view IEEE1394 source programs in the
POP window.
You cannot view two video or two antenna sources
in both the main and POP windows simultaneously.
(You can view a video source in one window and
an antenna source in the other.)
The FREEZE feature is not available when the POP
double-window is open. If you press FREEZE
when the POP double-window is open, the
message “Not available” will appear.
POP double-window
ENTER
Note: If you labeled all of the inputs as
HIDE (page 73), the POP feature will be
disabled and the message “NOT
AVAILABLE” will appear on-screen if you try
to open the POP double-window.