Filter
Top Products
NOTICE
PREPARATION
INTRODUCTION
RECORDING
OPERATION
PLAYBACK
OPERATION
Each time the + SET button is pressed, the display
changes as follows.
→ STOP → CONT.
STOP... Stops at tape end when any alarm condition has
occurred.
CONT .. Performs an operation selected by TAPE END
MODE on MENU SCREEN when tape end is
detected.
Setting the Alarm Recording
1
Press the DISPLAY
button.
3
Press the + SET button to set the alarm recording
time.
2
Press the SHIFT
button to blink SETUP
and press the + SET
button.
Recording time
5 seconds recording
15 seconds recording
30 seconds recording
1 minute recording
1 minute and 30 seconds recording
2 minutes recording
2 minutes and 30 seconds recording
3 minutes recording
6 minutes recording
Recording to tape end
Recording during alarm input
Display
5S
15S
30S
1M00S
1M30S
2M00S
2M30S
3M00S
6M00S
CONT.
MANUAL
4
Press the SHIFT button to blink SPEED and press
the + SET button to set the recording time mode.
Each time the + SET button is pressed, the display
changes as follows.
A2H → A6H → A12H → A18H → A24H → A2H
Each time the – SET button is pressed, the display
changes in the reverse order.
5
Press the SHIFT button to blink TAPE END
ALARM and press the + SET button to set operation
after tape end detection.
DISPLAY
TIME MODE
SET
SHIFT
TRACKING
LOCATION SELECT
+–
DISPLAY
TIME MODE
SET
SHIFT
TRACKING
LOCATION SELECT
+–