Filter
Top Products
16
Incoming Antenna/Cable(CATV) Signals
The VCR scans through all receivable TV and CATV channels and stores only the active
ones in your area into the memory. Once the storing is finished, you can select a desired
channel using CH/TRK.
Preparation
• Turn on the TV, and select the video channel (3 or 4) or the video input mode if you made the Audio/Video
connection (page 11).
• Press I.SELECT so that the channel number will appear if “L” is displayed in the VCR display.
Incoming Antenna/Cable(CATV) Signals
1
Press PROG. to display the MENU screen.
2
Select “PRESET” using FF or REW,
and press ENTER.
3
Select “CH MEMORY” using PLAY
or STOP, and press ENTER.
4
Set “TV/CATV“ to “TV” or “CATV” using FF or REW.
TV: To store channels received via the antenna.
CATV: To store channels received via the incoming cable.
5
Select “AUTO SCAN” using PLAY or
STOP, and press FF to set to “ON”.
The VCR starts scanning and the
channels are stored in the VCR in
ascending order. When the scanning is
finished, the screen automatically
returns.
6
Press PROG
.
twice to exit.
PREPARATION
Storing Channels on the VCR
This section is required if you receive only normal TV or unscrambled cable channels.
SLOW
PAUSE/STILL
REC TIMER
TV
VCR
POWER
I.SELECT
SP/ SLP
DISPLAY
TV VOL
COUNTER
PROG.
CANCEL
REMAIN/
RESET
COUNT
EJECT
CM SKIP
A.SELECT
ENTER
STOP
FF
REW
PLAY
REW
FF
PLAY, STOP
1,6
ENTER
1
2
3
6
5
4
9
87
0
I.SELECT
100
100
Number
buttons
W522CG ENG new (10-19) 2/20/04, 11:1716