70
[MENU]
Program System F
Select a conventional system F
Edit Sys Option F
Set Hold Time F
Set how long the scanner will remain scanning on this system before moving to the
next system (up to 255 seconds). Note that the scanner will scan all unlocked
channels at least one time, regardless of the system hold time setting.
[MENU]
Program System F
Select a system F
Edit Sys Option F
ID Scan/Search F
Sets whether the scanner only stops on talk groups you have programmed in (ID
Scan) or whether the scanner stops on any unlocked channel (ID Search).
[MENU]
Program System F
Select a system F
Edit Sys Option F
Set Delay Time F
This setting controls how many seconds the scanner waits after a transmission
ends before resuming scanning. Enter a value from [1] to [5] or Off,
then press
F.
Notes:
• The default setting is 2 seconds for each system.
• This setting applies to all channels within the system.
[MENU]
Program System F
Select a Conventional system F
Edit Sys Option F
Set Data Skip F
Setting the System Hold Time C
Setting ID Scan/ID Search MEL
Setting Channel Delay Time MELCS
Setting Data Skip C