Filter
Top Products
CHECKING THE CODES
If you have set up the Cox Universal Remote Control
using the Searching For Your Code procedure on the
previous page, you may need to find out which four-
digit code is operating your equipment. For example, to
find out which code is operating your TV:
1. Turn on your TV.
2. On the remote control, press TV once.
Then press and hold SETUP until the
TV key blinks twice, then release SETUP.
3. Enter 9 - 9 - 0. The TV key will blink twice.
4. To view the code for the first digit, press
1 once. Wait 3 seconds and count the number
of times the TV key blinks (for example,
3 blinks = 3) and write down the number in
the leftmost TV Code box (see below).
NOTE: If a code digit is “0”, the selected mode key
will not blink.
5. Repeat step 4 three more times for remaining
digits. Use 2 for the second digit, 3 for the
third digit, and 4 for the fourth digit. Write
down the remaining digits in the boxes below.
6. To check for other device codes, repeat steps
1–5, but substitute the appropriate key (that
is, AUX, VCR, or CABLE) for the (Auxiliary,
VCR, or Cable) device you are checking. Write
down the codes in the appropriate boxes
below.
AUX Code
Aux Device ____________________
VCR Code
TV Code
CABLE Code
12
Cox Manual - final - 082103.qxd 8/21/03 1:31 PM Page 12