Filter
Top Products
RE-ASSIGNING DEVICE KEYS
The Cox Universal Remote Control can be set up to con-
trol a second TV or VCR, or any combination of up to
four home entertainment devices. For example, to have
the unit control a TV, a Cable Converter, and two VCRs,
you will need to re-assign the unused AUX key to operate
the second VCR as follows:
1. On the remote control, press VCR once.
Then press and hold SETUP until the VCR key
blinks twice, then release SETUP.
2. Enter 9 - 9 - 2. The VCR key will blink twice.
3. Press VCR once, then press AUX once. The
VCR key will blink twice.
4. The AUX key is now ready to be programmed
for your second VCR. See Programming
Device Control on page 8.
To re-assign other device keys, repeat steps 1–4 and
substitute the key sequence using the following chart:
To Re-Assign Perform Key Sequence
TV as 2nd VCR key SETUP - 9 - 9 - 2 - VCR - TV
TV as 2nd
Auxiliary key
SETUP - 9 - 9 - 2 - AUX - TV
TV as 2nd Cable key SETUP - 9 - 9 - 2 - CABLE - TV
TV back to TV SETUP - 9 - 9 - 2 - TV - TV
VCR as 2nd TV key SETUP - 9 - 9 - 2 - TV - VCR
VCR as 2nd
Auxiliary key
SETUP - 9 - 9 - 2 - AUX - VCR
VCR as 2nd Cable key SETUP - 9 - 9 - 2 - CABLE - VCR
VCR back to VCR SETUP - 9 - 9 - 2 - VCR - VCR
AUX as 2nd TV key SETUP - 9 - 9 - 2 - TV - AUX
AUX as 2nd VCR key SETUP - 9 - 9 - 2 - VCR - AUX
AUX
as 2nd Cable key
SETUP - 9 - 9 - 2 - CABLE - AUX
AUX
back to
AUX SETUP - 9 - 9 - 2 - AUX - AUX
Upon completion of a re-assignment, the selected mode
key will blink twice to confirm your selection. Then,
you’ll need to program device control (see Programming
Device Control on page 8).
16
Cox Manual - final - 082103.qxd 8/21/03 1:31 PM Page 16