Filter
Top Products
Device Code Verification
You can verify any device code that you have pro-
grammed.This will be helpful in retrieving an
existing device’s Manufacturer Code programmed
into your Kameleon-C6 Remote for future refer-
ence.
TO VERFIY A DEVICE CODE
1.Press the desired device mode key on your
Kameleon-C6 Remote.
2.Press Setup for at least 3 seconds.The bottom
of the IR indicator will blink twice.
3.Press 9 9 0 on the keypad. The bottom of the IR
indicator will blink twice.
4.To determine the first digit of your 4-digit
code, press 1 and count the number of blinks
on the bottom part of the IR indicator. For
example,if there is one blink,then the digit is “1”
-– if there is two blinks,the digit is “2”– and so
on. If there are no blinks, the digit is “0.”
5.For the second digit,press 2 and count the
number of blinks .
6.For the third digit,press 3 and count the num-
ber of blinks .
7.Lastly, for the fourth digit, press 4 and count
the number of blinks .
R
EMEMBER
• Y
OUAREVERIFYING THE CODEFOR THE SELECTEDDEVICE
.
• I
FAFTER PRESSING9 9 0,ANYDIGIT OTHERTHAN 1 IS PRESSED,YOUR
K
AMELEON-C6 WILLEXIT THE SETUPMODE.
• I
FAKEY IS NOT PRESSEDWITHIN 30 SECONDS,YO UR KAMELEON-C6
REMOTE WILL EXIT THEDEVICE CODE VERIFICATION.
Adjusting Keypad Brightness
You can customize the backlight setting on your
Kameleon-C6 keypad.
TO ADJUST BRIGHTNESS
1.Press Setup for at least 3 seconds.The bottom
of the IR indicator will blink twice.
2.Press 9 7 4 on the keypad. The bottom of the IR
indicator will blink twice.
3.To increase the brightness press CH+.To
decrease the brightness press CH-.
4.Lastly, press Setup again to save the new
brightness setting.
14 Device Code Verification/Adjusting Keypad Brightness
KAMELEON-C6 REMOTE
Kameleon C6_v10.qxd 5/14/03 9:16 AM Page 14