Filter
Top Products
TO PROGRAM A LEARNED FUNCTION
1.Place your Kameleon-C6 Remote and your orig-
inal remote control on a flat surface.Position the
remotes no more than 1 to 2 inches apart. Make
sure the ends that you normally point at your
device are facing each other. See image below.
2.On your Kameleon-C6 Remote,press Setup for
at least 3 seconds.The bottom of the IR indicator
will blink twice.
3.Press 9 7 5 on the Kameleon-C6 keypad.The
bottom of the IR indicator will blink twice.
4.On your Kameleon-C6 Remote,press the
device mode key for which you want to copy the
learned function from your original remote.
5.On your Kameleon-C6 Remote,press the key
(e.g., F1 key) you want to save the Learned
function.The bottom of the IR indicator will
blink an “incoming IR”three times and your
Kameleon-C6 Remote will switch off.
6.Press and hold the original remote control’s
key (e.g., mono/stereo key on your original
remote control) until Kameleon-C6 keypad
switches back on. The bottom of the Kameleon-
C6’s IR indicator will blink twice to indicate a
successful transfer.A long blink indicates failure.
7.If you want to copy other functions from the
same original remote,simply repeat steps 5 and
6,pressing the next key you want to copy.
8.Lastly, to exit the Learning Feature,press Setup
on your Kameleon-C6 for at least 3 seconds.The
bottom of the IR indicator will blink twice.
R
EMEMBER
• AFTER THEKAMELEON-C6 KEYPAD SWITCHES OFFIN STEP 5,YO U NEED
TO PRESS THE KEYONYOURORIGINALREMOTE WITH IN 5 SECONDS.
OTHERWISE,YO UR KAMELEON-C6 REMOTE WILL EXIT THE LEARNING
MODE.
• A
FTER 30 SECONDS OFINACTIVITYWHILE IN LEARNING FEATURE,THE
REMOTE WILL EXIT THE
LEARNINGMODE.
• I
N THELEARNING MODE,KEYSSUCHAS “TV MENU”WILL NOTCHANGE
THE SCREEN WHEN PRESSED.
• I
FYOU WANT AKEY THATIS NOTIN THE MAIN SCREENTO LEARNA
FUNCTION,USE THESCROLLKEY TOCHANGE THE SCREEN.
18 The Learning Feature
KAMELEON-C6 REMOTE
KAMELEON
-C6 REMOTE
ORIGINAL
REMOTE
1 TO
2
INCHES
APART
Kameleon C6_v10.qxd 5/14/03 9:16 AM Page 18