Filter
Top Products
21
Type in Section Title
M
X
9
5
0
T
X
1
0
0
0
M
X
9
0
0
L
C
D
R
E
M
O
T
E
S
COMPLE TE
CONTROL
™
2 Select the button that you want to teach to by single clicking it on the simulator.
3 Click on the LEARN Tab or choose Learn from the Program. There will be a pause, while the PC
communicates with the MX-950, then the info window will display “Ready”.
4 Press and hold the corresponding button on the original remote control while pointing it at the top
of the MX-950 (head to head) with the remotes approximately a half inch to an inch apart. When the
code is successfully learned, the window will say GOOD, confirming that the code learned “correct-
ly.” Actually, the GOOD means that the code might be good.... You need to test it. Select the code
in the Current Learned IR List, then click on the test button while pointing the MX-950 at the device.
TIP - Always POWER OFF the RF Base Station when testing Learned Codes. Test line-of-sight only!
If there is any interference or IR saturation, your tests will fail, not because of learning issues but
because of RF setup issues. Don’t waste time, test your codes now, test RF setup later.
Learning
The Learn Button re-activates the Learning process when it auto-
matically times out or if you want to re-learn a command.
The Learning Information window prompts you when the system
is Ready to learn a new command and when a learned com-
mand is Good, or if it Fails.
The Learn Tab reveals the toolbar for Learning.