Filter
Top Products
Repeat steps one through nine for each of your devices. Test all the
commands you’ve programmed. If you are missing any commands,
use the learning method, described next:
10
9
Universal Remote Control, Inc.
Learning Method
The Omega can learn commands from your old remote controls one-
button-at-a-time on any button of any device, on the MAIN or FAV LCD
buttons or on the MAIN hard buttons, by following these simple steps:
Line-up the Omega with your old remote control, head-to-head,
one or two inches apart.
On the Omega, press and hold the MAIN and ENT (Enter) buttons
at the same time for approximately three seconds. The top of the
display will show “SETUP”. You are in SETUP mode now.
Note: You have 30 seconds to perform a step while you are in SETUP mode. If
you don’t press a button within that time, the Omega will time out and return to
normal operation.
Press the LEARN button.
The top of the screen will change to “LEARN”.
LEARN
Button
1
2
3