Universal Remote Control omega MX-650 Universal Remote User Manual


 
31
Universal Remote Control, Inc.
Press the RF button.
The RF Settings Menu appears. See the notes on the following
pages for more info on each option. Make your selection by press-
ing the button you want:
After you’ve made a new setting and SAVED your change, use the
EXIT button to return to the Setup menu. Use the MAIN button to
return to normal operation.
IR/RF Signal Setting
You can set the signal to be IR line-of-sight only, RF only or IR and RF
simultaneously. Additionally, you can set the signal the same way for ALL
ten of your devices OR you can set the signal differently for each device
(the plasma TV could be set to be IR line-of-sight only, while the DVD
player and the Satellite receiver are set to be RF only). A good reason to set
the signal to RF only is to prevent too much IR being sent to a sensitive
component from two arrivals at the front panel (one directly from the
Omega, one from the RF base station). A good reason to set the signal to
IR only is that another room has an MRF-100 base station (no RF address)
so it will receive commands from the Omega unless it is set to IR only.
3
4
5
RF Button
Signal (IR,
RF or Both)
Base Station
ID #
Emitters - ALL
or a specific
Emitter
Blaster - Turn
the Blaster
On or Off
Exit this Menu