Universal Remote Control omega MX-650 Universal Remote User Manual


 
34
EMITT - Setting IR Emitter Outputs
The MRF-250 and MRF-300 Base Stations enable you to route or
steer the IR commands from any Device to any or all of the IR
Line Outputs. This allows you to control identical devices using
the exact same IR commands (such as an array of television sets
in a media room or a stack of identical satellite receivers installed
in a central location with one satellite receiver dedicated to each
room with a television). Each button push (or macro step) is rout-
ed to the specific IR Line Output you’ve assigned to a device. In
the factory set default settings, the Omega is set to route IR com-
mands from any device to ALL IR Line Outputs simultaneously. To
change the Omega default settings follow these steps:
From the RF Settings Menu, select EMITT.
Decide whether you are changing the Emitter settings for all devices
or just one of the devices of the Omega.
Select ALL to change the Emitter settings to
ALL devices in the Omega. Then, go to Step
4.
Select DEVIC to change the Emitter settings
to just one of the devices in the Omega.
Then, go to Step 3.
The Omega
1
2
Select the new setting by pressing the desired button, then press SAVE
to save your new setting and return to the RF settings menu.
4
Change ID#
using UP and
DOWN buttons
Displays the
current ID#
Save the new setting
Exit this Menu with-
out changing the
IR/RF settings