Filter
Top Products
4. Aim the remote control at the TV and
slowly alternate between pressing
POWER
and TV. Stop when the TV turns off (after
pressing
POWER).
NOTE:In the search mode,the remote control
will send IR codes from its library to the selected
device,starting with the most popular code first.
5. To lock in the code,press and release SET.
The
LED will blink twice.
6. To search for the codes of your other
devices,repeat steps 1 through 5,but
substitute the appropriate device key for
the device you are searching for.
CHECKING THE CODES
If you have set up the remote control using the
Searching For Your Code procedure (on the previous
page),you may need to find out which four-digit code
is operating your equipment.
For example,to find out which code is operating your TV:
1. On the remote control,press
TV once.
2. Press and hold SET until the LED (red light)
blinks twice,then release
SET.
3. Enter 9 - 9 - 0.The LED will blink twice.
4. To view the code for the first digit,press
1
once.Wait 3 seconds,count the LED
blinks (e.g.,three blinks = 3) and write
down the number in the leftmost box in
the TV code boxes on page 10.
NOTE:If a code digit is “0”, the LED will not
blink.
5. Repeat step 4 three more times for
remaining digits.Use
2 for the second
digit,
3 for the third digit,and 4 for the
fourth digit.Write down the code digits in
the remaining TV code boxes on page 10.
6. To check for codes of other devices,repeat
steps 1 through 5,but substitute the
appropriate device key for each device you
are checking.Write down the device’s code
digits in the appropriate code boxes on
page 10.
11
IMPVE4P manual 1.0 4/11/03 4:34 PM Page 11