Filter
Top Products
PROGRAMMING FAVORITE CHANNEL SCAN
In the DVD/VCR,CBL/SAT,or TV mode, you can store a list
of up to 10 favorite channels, in any order,that will be
immediately scanned when
FAV is pressed (see Using
Channel Scan on the previous page).
NOTE: Favorite channels can only be programmed for one
mode.After programming, if FAV is pressed while in another
mode, the remote control will start scanning all channels
instead (if applicable to the selected device).
1. On the remote control,press DVD/VCR,
CBL/SAT,or TV once.
2. Press and hold SET until the LED (red light)
blinks twice,then release
SET.
3. Enter 9 - 9 - 6.The LED will blink twice.
4. Use the keypad to enter a favorite channel
number (e.g., 031).Then press SET once.
NOTE: If the original remote control required
pressing an Enter key to change the channel,
also press the ENTER key after the channel
number (e.g., 0 - 3 - 1 - ENTER).
5. If desired,repeat step 4 for each channel
to be stored,up to a total of 10 channels.
NOTE:If you try entering more than
10 channels,the remote control will
automatically exit programming.
6. To exit programming with less than
10 favorite channels stored, press and hold
SET until the LED blinks twice.Otherwise,
the remote control will automatically exit
the program after ten channels have been
stored.
16
IMPVE4P manual 1.0 4/11/03 4:34 PM Page 16