Filter
Top Products
Page 11
Three-Digit Code Entry Method
STEP 1: Find the 3-digit code numbers
assigned to your brand from the lists in the
back of this manual. The codes are listed by
component category (i.e., TV, VCR, DVD,
etc.), then by brand name. For instance, if
you would like to locate a code for a Sony
television, first locate the TV category and
then look for the Sony brand.
STEP 2: Once you have located the 3-
digit codes for each of the components that
you wish to operate with your WR7, write
them ALL down on a piece of paper. It’s
important that you write down all the codes
listed for your brand because only one code
is going to work with your component.
STEP 3: Manually or using your old
remote, turn on the component you want to
program—for example, to program your TV
turn on your TV set.
STEP 4: On the WR7, press the
Component button that you want to program
(in this case the button that says TV) and the
SELECT [SEL] button at the same time. Hold
down both buttons for two seconds until the
TV Component LED light turns on. This sig-
nals that you are in programming mode.
COMPONENT
BUTTONS
SELECT
BUTTON