Filter
Top Products
Page 30
Erasing Commands -
Overview
You can erase a single learned command, all
learned commands in each component mode,
SimpleSound programming, MacroPower com-
mands, or re--set the remote to original factory
default settings.
Erasing a Single Learned Command from
One Component
STEP 1: Press the component button where
the learned command is stored and the [ENTER]
button at the same time for two seconds until the
component LED light turns on.
IMPORTANT: You have 30 seconds to per-
form the next step while you are in programming
mode. If you do not press a button within 30 sec-
onds, the component LED light will turn off. The
remote will exit the programming mode and you
will have to start over.
STEP 2: Press and hold the button you
want to erase for two seconds. The compo-
nent LED light will blink twice to confirm the
erasure.
STEP 3: Repeat Step 2 to erase any other
buttons in the selected component mode.
STEP 4: To exit Erase mode, press and
hold both the component button and the
[ENTER] button at the same time until the
component LED light blinks three times.
COMPONENT
BUTTONS
ENTER