Filter
Top Products
Page 14
Auto-Search Method
The Auto-Search Method is a way you can
scan through all of the codes in the table to
find the right code for your component.
STEP 1: Manually or using your old remote,
turn on the component you want to pro-
gram—for example, to program your TV,
turn on your TV set.
STEP 2: On the WR7, press the Component
button that you want to program (in this
case the button that says TV) and the
SELECT [SEL] button at the same time. Hold
down both buttons for two seconds until the
TV Component button light turns on. This sig-
nals that you are in programming mode.
IMPORTANT: You have 30 seconds to per-
form the next step while you are in program-
ming mode. If you do not press a button
within 30 seconds, the component LED light
will turn off. The remote will exit the pro-
gramming mode and you will have to start
over.
DOWN
ARROW
UP
ARROW