Filter
Top Products
Page 17
STEP 4: Press and hold the [MUTE] button
on the other remote until the component but-
ton LED on the WR7 blinks twice. Now you
can continue learning all other buttons from
your old remote by pressing the next button
on the WR7 and repeating this step.
Note: The component LED will blink five times
if there was an error in the learning process. In
this case, please repeat Steps 3 and 4.
STEP 5: Once the WR7 has learned all
the buttons in the selected component mode,
press and hold the Component button and
ENTER [ENT] buttons at the same time to
save the learned functions. The component
LED light will blink three times to confirm the
programming. Now test all the buttons to
make sure they learned correctly.
Repeat Steps 1-5 to program any other com-
ponent modes.
If the Learning Method does not
work, here are a few suggestions:
• If you have a Plasma TV, move to another
room
• Avoid programming under fluorescent light
or direct sunlight
• Put new batteries in the old remote
• Gradually vary the distance between the two
remote controls
• Adjust the angles of the remotes (i.e., keep
the WR7 on a flat surface while holding the
other remote in hand and angling it down
toward the WR7)
• Tap the button on your old remote instead of
pressing and holding it during the learning
process