Filter
Top Products
Page 27
Channel Control “Punch Through”
This “punch through” enables you to program
the WR7 so that either the Cable or TV
Channel Controls (CHANNEL UP, DOWN,
LAST, CHANNEL NUMBERS 0-9, +10 and
ENTER) will also operate in other component
modes on the remote control.
STEP 1: Press and hold the component but-
ton you want to add channel control to, such as
[DVD] or [VCR], and the SELECT [SEL] button at
the same time for two seconds until the
Component LED light turns on.
IMPORTANT: You have 30 seconds to per-
form the next step while you are in program-
ming mode. If you do not press a button within
30 seconds, the component LED light will turn
off. The remote will exit the programming mode
and you will have to start over.
STEP 2: Press the CHANNEL UP [CH
]
button. The component LED light will blink once.
STEP 3: Press either the [TV] or [CABLE/SAT]
button that you want to use as the source of
channel control. The component LED will blink
three times to confirm it is saved.
COMPONENT
BUTTONS
CHANNEL
UP
SELECT