Filter
Top Products
Operation
Vidikron Vision 85 Owner’s Operating Manual 69
PRE
L
IMINAR
Y
HD/RGB Adj. Select HD/RGB Adj. from the Main Menu to view input signal resolution and timing
information.
Signal Info: Select Signal Info from the HD/RGB Adj. menu to display the resolution,
horizontal frequency and vertical frequency of the input current signal.
OptionsSelect Options from the Main Menu to perform the following projector configuration tasks.
Image Shift: Select Image Shift from the Options menu to vertically shift the projected
image.
Subtitle: Select Subtitle from the Options menu to adjust the projected image height in
small increments.
Overscan: Refer to Overscan on page 55.
Default: To reset the Overscan setting to its default value, select Default from the Options
menu, then select Yes to confirm the reset.
LED: Select LED from the Options menu to change the behavior of the projector’s indicator
LEDs.
• When set to ON, the LEDs indicate operating status as described in Vision 85 at a Glance
on page 5.
• When set to OFF, the LEDs illuminate when the Vision 85 is in standby mode, warming up
or indicating an error condition; otherwise, they are off.
Lamp Hours (read-only): Refer to Lamp Hours on page 61.
OSD: When you select an aspect ratio or input with the remote control (or from the VHD
Controller), the Vision 85 displays your selection on-screen. To prevent the display of these
items, select
OSD from the Options menu and set it to Off.
HD/RGB Adj.
Frequency 0
Phase 0
H-Shift 0
V-Shift 0
Default
Special Modes
Signal info
Auto Setup
Ima
g
e Shift 0
Subtitle 0
Overscan 30
Default
Adjust Black Level 0
LED
On
Options
OSD On
Signal Type 3
Lamp Hours
HDMI Black Level 0
Color Space
Auto
Background
Power Save
Baud Rate 9600 bps
Fan Mode 2
Orientation
FF
Factory Default
Adjust White Level 0
Overscan +
-
5%
Image Shift and Subtitle can only be adjusted for certain 1080i signals.
When you set the Auto Power Off function (refer to Power Save, below) to
Off, the LED function is automatically set to On.
Note
Note