Filter
Top Products
Installation
30 Vidikron Vision 70 Series Owner’s Operating Manual
PRE
L
IMINAR
Y
Connecting 12-volt Trigger
Output to External Theater
Equipment
If your Vision 70 is equipped with a CineWide with AutoScope system, use the cable supplied
with the AutoScope Lens Motor to connect the motor to the 12-volt trigger output as shown
in
Figure 3-14.
Figure 3-14. Connecting the 12-volt Trigger Output to the AutoScope Lens Motor
If your home theater contains a retractable screen, screen mask or other 12-volt
trigger-activated equipment, use the cable supplied with the Vision 70 to connect it to the
12-volt trigger output as shown in
Figure 3-15.
Figure 3-15. Connecting the 12-volt Trigger Output to Other Equipment
➤
AutoScope
Lens Motor (Rear)
AC Input
Power
Switch
S-VID /
S-VID
3.5-mm
mini plug
S-VID /
S-VID
to other,
12-volt
trigger-activated equipment
(screen, screen mask etc.)
Red = +12V (Tip)
Black = Ground (Sleeve)
3.5-mm
mini plug