Filter
Top Products
Installation
Vidikron Vision 70 Series Owner’s Operating Manual 35
PRE
L
IMINAR
Y
The anamorphic lens will almost always be angled with respect to the projector; this is
normal.
Once the proper lens angle has been set, firmly tighten the Pitch Adjustment Screws to
secure the lens in place.
Adjusting the Yaw: Loosen the Yaw/Z-Adjustment Levers to allow the lens to pivot freely
from side to side. Then, angle the lens to even out any left-right pincushion distortion:
There may be some pincushion distortion even after the lens is properly
adjusted, especially at shorter throw distances. If this is the case, Vidikron
recommends that you slightly over-scan the image into the screen frame
area to mask the distortion.
Correct Lens Angle
Incorrect Lens Angle
Note
Anamorphic Lens (Top View)
Wrong Position
Correct Position