Filter
Top Products
Installation
Vision Model 140/150 Installation/Operation Manual 19
PRE
L
IMINAR
Y
3.2
Quick Setup
Table 3-1 gives a quick overview of the Vision 140/150 installation process. The sections
following this one provide detailed instructions.
Installation should be performed by a qualified custom video installation
specialist.
Table 3-1. Installation Overview
Step Procedure
For Details, Refer to
page...
1
Choose a location for the projector 20
2
Install primary projection lens 26
3
Install CineWide lens mounting assembly (stationary base
plate or AutoScope lens motor – optional)
27
4
Mount the projector 29
5
Connect the VHD Controller to the projector 30
6
Connect signal sources to the VHD Controller 31
7
Connect external controller to RS-232 port (optional) 35
8
Connect other home theater components to 12-volt trigger
outputs (optional)
36
9
Apply power to the projector 37, 38
10
For rear-screen and/or ceiling-mount installations, select the
proper picture orientation
39
11
Primary lens adjustments: projected image size (zoom),
position (shift) and focus
22, 39
12
Install CineWide anamorphic lens (optional) 40
13
CineWide lens adjustments: projected image size (zoom),
position (shift) and focus
41
14
Calibrate projector input 2 (DVI): perform Auto Setup, then
adjust size/position, input levels, brightness/contrast etc., as
needed for each channel
45
15
Adjust lamp output and optical aperture, as needed 59
16
VHD Controller input calibration: adjust the following for
each VHD Controller input; save settings when finished:
• Aspect ratio
• Brightness
• Contrast
• Color level
• Tint
• Input position
65 through 73
Note