Filter
Top Products
Operation
60 Vidikron Vision 85 Owner’s Operating Manual
PRE
L
IMINAR
Y
Remote Control: The Remote Control menu shows you the primary and secondary infrared
(IR) codes to which the Vision 85 will respond. By default, both are set to 17. You can change
these codes if either:
• Another device in the theater (a DVD player, for example) is responding to commands
from the Vision 85/VHD remote control (
Figure 2-5) in ways that are unpredictable or
undesirable.
• You have multiple Vision 85 projectors and want to control them independently, as
opposed to broadcasting commands from a single remote to all of them. In this scenario,
you can use multiple remotes programmed to use different IR codes. Or, you can use a
single remote and change the IR code as needed to address a specific projector.
When you change a remote code on the Vision 85, you must re-program the Vision 85/VHD
remote control to send that same code. To do this:
1. Using a straightened paper clip or similar object, press and hold the
CODE button on the remote control for approximately three
seconds, or until the LED on the remote lights solid red.
– OR –
If your remote control unit does not have a CODE button, press and
hold the LIGHT button on the remote control for approximately
three seconds, or until the LED on the remote lights solid red.
2. Enter a new two-digit code between 00 and 31 inclusive. Use the
16:9 button for “9” and the 4:3 button for “0.” Include a leading
zero for single-digit codes; for example, enter 9 as “09.”
3. The LED turns off to confirm the code change. If you enter an invalid code, the LED
flashes for three or four seconds. Try again, entering a valid code.
Use the VHD Controller front-panel keypad to change the projector IR
code. Then, change the code sent by the remote to match as described
below.
Do not change the “Type” setting in this menu.
Tip
Note
N
T
CODE