Vizio L37 Flat Panel Television User Manual


 
www.VIZIOCE.com
Version- 10/5/05
56
VIZIO L37 HDTV User Manual
Chapter 4 - Maintenance and Troubleshooting
4.1 - Maintenance
Important
1. Make sure that the power cable is removed from the socket before cleaning the display.
2. Do not use volatile solvent (such as toluene, rosin and alcohol) to clean the display. Such chemicals may
damage the housing, screen glass and remote control, and cause the paint to peel.
Cleaning the Housing and the Remote Control
1. Use a soft cotton cloth for cleaning.
2. If the housing or remote control is seriously contaminated, use a soft cloth moistened with diluted neutral
cleaner to clean the display. Wring water out of the cloth before cleaning to prevent water from
penetrating into the housing. Wipe the display with a dry cloth after cleaning.
Cleaning the Screen
1. Use a soft cotton cloth to gently clean the screen.
2. The screen glass is very fragile. Do not scrape it with any sharp object. Do not press or tap the screen to
avoid cracking. When the screen is seriously contaminated, use a soft cloth moistened with diluted neutral
cleaner to clean the display. Wring water out of the cloth before cleaning to prevent water from
penetrating into the housing. Wipe the display with a dry cloth after cleaning.
4.2 - Troubleshooting Guide
If the display fails or the performance changes dramatically, check the display in accordance with the
following instructions. Remember to check the peripherals to pinpoint the source of the failure. If the display
still fails to perform as expected, contact the dealer for assistance.
Problem Solution
Check your audio connection.
Press MUTE on the remote control again, so that MUTE disappears from
the screen.
Check your audio settings, your TV audio may be set to SAP or minimum.
Press the Volume + (Up) key on your remote control.
Make sure that headphones are not connected.
Check to see if your speakers are turned on or off. (See page 28)
Make sure the AC power button is ON, DC power button is ON (Green LED).
Make sure AC power cord is securely connected to the AC socket.
Plug another electrical device (like a radio) to the power outlet to verify that the
outlet is supplying the proper voltage.
There is not any power.
There is not any sound.