Filter
Top Products
VIZIO VP50HDTV User Manual
Version 4/17/2007 8
www.VIZIOCE.com
Chapter 1 Basic Controls and Connections
1.1 Front Panel
Power LED – Lights green when powered on, yellow
when powered off.
Remote Control Sensor – This is the window through
which all of the remote control signals pass to the
sensor. Point the remote control directly at this
window for the best response to the remote signal.
1.2 Side Panel Controls
Power (
) – Switch the VP50HDTV on by pressing the button once.
Press the button again to the VP50HDTV off.
Menu – This button activates the On Screen Display (OSD). If a sub-
menu is active, pressing this button will return to the previous menu level.
Channel ▲/▼ – Use these buttons to step up or down the TV channels.
While the OSD is active, these buttons function as up and down controls
in the OSD menus.
Volume ◄/► – Use these buttons to increase or decrease to the
speaker volume. While the OSD is active, these buttons function as left
and right controls in the OSD menus.
Input (Enter) – Repeated pressing of this buttons steps through the
input sources in the following sequence: DTV, TV, RGB, AV1 (S-Video or
video*), AV2 (S-Video or video*), Component 1, Component 2, HDMI 1,
and HDMI 2. Once you have stepped through the entire sequence, you
will return to the beginning.
Additionally, when the OSD is active, this button confirms the menu function to be adjusted. When the
OSD is not active, pressing this button will display the current input mode.
*S-Video has priority. If a signal is connected to AV1 S-Video by itself or signals are connected to AV1 S-Video and AV1 Video
simultaneously, then S-Video will be the only choice for AV1. If a signal is connected to AV1 Video only, then Video will be the only
choice for AV1. The same input priority scheme applies to AV2.