Filter
Top Products
Tools Needed:
Cable stripper
Compression tool
for compression
connectors
Hex crimp tool for
hex crimp connectors
Strip outer cover back
12 mm from end of
cable.
Fray braid back as far
as outer cover will
allow.
Trim braid close to
outer cover, and
remove 6 mm of
inner insulation, being
careful not to nick
the center conductor.
Make sure no foil
or braid can touch
center conductor.
Slide connector tip
between braid and
inner insulation
(braid and foil, on foil
shield cable). Push
connector on cable
as far as it will go.
Attach cable with
proper crimping or
compression tool. Do
not crush cable out-
of-round.
Installing Connector on Coax Cable
TIP
If installing in hot
weather, increase
these dimensions 3 mm.
Notes
Parts
Mount
Nut
Nylon Bearing
Gear Housing
Nylon Bearing
Q-Ring
Base Plate
Plug
Worm Gear
Mounting Screw
Directional Handle & Ceiling Plate
Crank (white)
Spring
Nylon Bearing
Screw
Decal
Directional Handle
(white)
Ceiling Plate
(white)
ORDERING REPAIR PARTS
Repair parts are available at many RV dealers and/or
service centers throughout the country. If you don't
have a dealer/service center near you, call Winegard
Company at 1-800-288-8094. All major credit cards
accepted. Parts are available only in the packages
shown on the following pages. Order by the model
number of the package needed. Example: To order
the elevating gear, order RP-3000. Tax, shipping and
handling additional.