Woods Equipment 1022120 TV Mount User Manual


 
12 Installation
MAN0708 (4/11/2008)
Install Hydraulic Block and Fittings
1. Locate the hydraulic manifold block on the right
side of the tractor just under the fender (Figure
19) and remove the block-off cap.
2. Attach hydraulic block (18) to tractor using new
O-rings (14), three cap screws (8) and one cap
screw (9) plus washers (7). Make sure O-rings
are properly seated during installation.
3. Install elbows (15) and (11) into ports shown in
Figure 20. Point elbows rearward.
7. 2472 5/16 Lock washer
8. 307130 M8 x 1.25P x 40 mm Cap screw
9. 307134 M8 x 1.25P x 100 mm Cap screw
11. 313049 Elbow, 9/16 ORBM x 9/16 JICM 45°
14. 62726 O-ring .487 x .103
15. 63558 Elbow, 9/16 JICM x 9/16 ORBM
18. 1011423 Hydraulic block
Figure 19. Hydraulic Manifold Location Figure 20. Hydraulic Block and Fitting Installation
Install Hydraulic Hoses
1. Attach male quick coupler (17) to end of hose (2).
2. Connect opposite end of hose (2) to 90-degree
elbow (15) in the hydraulic block. Route hose
over rear axle and out the back of the tractor.
3. Attach straight end of hose (12) to 45-degree
elbow (11) on the hydraulic block.
4. Attach 90-degree end of hose (12) to elbow (13)
connected to the bulkhead adapter bracket.
Figure 21. Hydraulic Hoses Installed
Figure 22. Hydraulic Hose Installation
2. 1009493 Hose, 40" x 3/8 NPTM x 9/16 JICF
11. 313049 Elbow, 9/16 ORBM x 9/16 JICM
12. 360215 Hose, 14" x 9/16 JICF x 9/16 JICF
13. 38604 Elbow, 9/16 JICM x 9/16 JICF 90°
15. 63558 Elbow, 9/16 JICM x 9/16 ORBM
17. 64300 Quick coupler, male
DP19
DP20
2
12
13
15
11