Filter
Top Products
Installation 7
MAN0708 (4/11/2008)
Install ROPS Brackets
1. Place ROPS bracket (33) under rear axle and
secure to ROPS using two cap screws (30) and
hardened flat washers (28).
NOTE: Bracket must be orientated with the
"short" side towards the outside of the tractor.
2. Repeat for opposite side of tractor.
30. 59036 M12 x 1.75P x 150 mm HHCS
28. 57816 1/2 Hardened flat washer
33. 1022125 ROPS bracket, link
Figure 7. ROPS Bracket Installed - Right Side
Install Tractor Brackets
With Woods LS84 Loader Mount
1. Place left tractor bracket (4) under left side of
tractor. Use a hydraulic floor jack to help raise
and hold tractor bracket in position.
2. Attach left tractor bracket (4) to left loader mount
using two cap screws (32), four hardened flat
washers (29), and two hex nuts (23).
3. Attach tractor bracket to the bottom of ROPS
bracket (33) using four cap screws (26), eight
hardened flat washers (28), four hex nuts (21).
4. Place right tractor bracket (3) under right side of
tractor. Use a hydraulic floor jack to help raise
and hold tractor bracket in position.
5. Attach right tractor bracket (3) to front mount (10)
using two cap screws (32), four hardened flat
washers (29), and two hex nuts (23).
6. Attach tractor bracket to the bottom of ROPS
bracket (33) using four cap screws (26), eight
hardened flat washers (28), four hex nuts (21).
Figure 8. Tractor Brackets Installed with LC84 Loader
33
DP2
30
3. 1022130 Right tractor bracket
4. 1022131 Left tractor bracket
10. 1026846 Front mount (LS84 only)
21. 1093 1/2 NC Hex nut
23. 230 5/8 NC Hex nut
26. 3699 1/2 NC x 2 HHCS GR5
28. 57816 1/2 Hardened flat washer
29. 57817 5/8 Hardened flat washer
32. 902 5/8 NC x 2 HHCS GR5
33. 1022125 ROPS bracket, link