Filter
Top Products
Installation 5
MAN0708 (4/11/2008)
BACKHOE SUB-FRAME INSTALLATION
Tractor Preparation
■ Only use 1022120 4-Point Sub-Frame Mount-
ing Kit for mounting Woods BH70-X, BH80-X
backhoe on New Holland
®
T1510, T1520 tractor
equipped with Woods LS84, LC96, LC102, 1009,
1012 loaders or New Holland 7308, 110TL loaders.
Any other use or modification of this mounting kit
may result in serious injury or death.
For installing this sub-frame, references to right, left,
forward and rearward directions are determined from
the operator’s position in the tractor seat.
Do not install 1022120 4-point sub-frame on a tractor
without a Woods or New Holland loader mount
attached.
Refer to the WOODS BH70-X, BH80-X Backhoe
Operator’s Manual for backhoe assembly instruc-
tions.
Leave all hardware loose until sub-frame has been fit
up or otherwise specified in the instructions.
This mount can be installed on tractors equipped with
a New Holland mid-mount mower. Sub-frame can be
installed with mower attached but may be easier if
mower is removed from tractor.
1. Place jackstands under rear axle and remove
both rear tires.
2. Disconnect the tractor anti-sway links from the
axle brackets (Figure 1). Secure sway links to 3-
point arms.
3. Remove top link.
4. Remove ROPS hardware from both sides of rear
axle. See Figure 2.
Figure 1. Disconnect Anti-Sway Links
(Right Side Shown)
Figure 2. ROPS Hardware - Left Side Shown
DP17
DP1
As a valued customer, Woods appreciates your comments. Once sub-frame and hydrau-
lic hoses have been installed, please take a few minutes to complete the Sub-Frame
Mount Evaluation sheet that was supplied with your sub-frame. Your comments will help
us continue to bring you quality products.