Woods Equipment 1022120 TV Mount User Manual


 
Installation 9
MAN0708 (4/11/2008)
Install Cross Brace
1. Remove PTO shield.
2. Attach cross brace (6) to rear of tractor using two
hex flange screws (20).
3. Attach to right and left tractor brackets using four
(two per side) cap screws (26), eight hardened
flat washers (28), and four hex nuts (21).
4. Install PTO shield.
6. 1013477 Cross brace
20. 1026373 M16 x 2.0P x 40 mm HFS CL10.9
21. 1093 1/2 NC Hex nut
26. 3699 1/2 NC x 2 HHCS GR5
28. 57816 1/2 Hardened flat washer
Figure 11. Cross Brace Installed
Figure 12. Cross Brace Installation
Install Reinforcement Brackets
1. Place reinforcement bracket (7) on the outside of
right tractor bracket.
2. Secure to front holes using two cap screws (32),
six hardened flat washers (29), and two hex nuts
(23).
3. Secure to rear holes using two cap screws (32),
six hardened flat washers (29), and two hex nuts
(23).
4. Repeat steps to install bracket (7) on left side.
Figure 13. Offset Bar Installed, Right Side
3. 1022130 Right tractor bracket
7. 1022126 Reinforcement bracket
23. 230 5/8 NC hex nut
29. 57817 5/8 Hardened flat washer
32. 902 5/8 NC x 2 HHCS GR5
Figure 14. Offset Bar Installation, Right Side
20
26
28