Filter
Top Products
Installation 5
MAN0715 (Rev. 10/31/2008)
BACKHOE SUB-FRAME INSTALLATION
Tractor Preparation
■ Only use 1028310 4-Point Sub-Frame Mount-
ing Kit for mounting Woods BH90-X backhoe on
New Holland
®
TT60A or TT75A tractors equipped
with Woods LU126 loader. Use mount kit 1029700
and 1028310 Sub-Frame Mounting Kit to mount
Woods BH90-X backhoe on New Holland
®
TT60A
or TT75A tractors equipped with New Holland
620TL Loader. Any other use or modification of
this mounting kit may result in serious injury or
death.
For installing this sub-frame, references to right, left,
forward and rearward directions are determined from
the operator’s position in the tractor seat.
Do not install 1028310 4-point sub-frame on a tractor
without a Woods or New Holland loader mount
attached.
Refer to the WOODS BH90-X Backhoe Operator’s
Manual for backhoe assembly instructions.
Leave all hardware loose until sub-frame has been fit
up or otherwise specified in the instructions.
1. Place jackstands under rear axle and remove
both rear tires.
2. Disconnect the tractor anti-sway links from the
axle brackets. Secure sway links to the drawbar
bracket with sway link pins and safety pins (22)
supplied in kit. See Figure 1.
3. Remove top link.
4. Remove the lower ROPS bracket from the bottom
of the rear axle (Figure 2). Leave ROPS bolts in
place.
NOTE: Only work on one side of the tractor at a
time. ROPS may become unstable if both ROPS
brackets are removed at the same time.
5. 1028360 Hose Kit Only: Disconnect the loader
valve PBY hose from the tractor steel hydraulic
line under the right side of the operator’s platform.
6. Disconnect the steel hydraulic line from the
hydraulic valve at the rear of the tractor and
remove the hydraulic line. See Figure 2.
Figure 1. Reposition Anti-Sway Links
Figure 2. Remove Hydraulic Line & ROPS Bracket
(Right Side Shown)
DP1
Remove
Remove
DP2
As a valued customer, Woods appreciates your comments. Once sub-frame and hydrau-
lic hoses have been installed, please take a few minutes to complete the Sub-Frame
Mount Evaluation sheet that was supplied with your sub-frame. Your comments will help
us continue to bring you quality products.