Woods Equipment 1028310 TV Mount User Manual


 
6 Installation
MAN0715 (rev. 10/31/2008)
Install 1029700 Mount Kit
For New Holland Loader Mount Only
This mount kit is needed to connect sub-frame mount-
ing kit 1028310 to the New Holland 620TL loader
mount.
1. Remove toolbox and toolbox bracket from the
right loader mount if equipped.
2. Attach right backhoe bracket (1) to the inside of
New Holland loader mount and toolbox bracket
(3) to the outside of loader mount.
3. Secure using two cap screws (4), hardened flat
washers (5), one tube support (7) and two flange
lock nuts (6).
NOTE: Tube support (7) is placed between the
two rear holes on the mount.
4. Attach toolbox to toolbox bracket (3) using hard-
ware previously removed.
5. Repeat steps to install left backhoe bracket (2) to
left loader mount. See Figure 5.
1. 1029702 Right backhoe bracket
2. 1029703 Left backhoe bracket
3. 1029704 Toolbox bracket
4. 300469 5/8 NC x 6-1/2 HHCS GR5
5. 57817 5/8 Hardened flat washer
6. 19025 5/8 NC Flange lock nut
7. 1029774 Tube support
Figure 3. Right Backhoe Bracket Installation
Figure 4. Right Backhoe Bracket Installed
Figure 5. Left Backhoe Bracket Installed
7
3
6
4
1
DP7
6
4
2
7