Filter
Top Products
Installation 7
MAN0715 (Rev. 10/31/2008)
Install Tractor Brackets
1. Place right tractor bracket (1) under right side of
tractor. Use a hydraulic floor jack to help raise
and hold tractor bracket in position.
2. Attach right tractor bracket (1) to right loader
mount or right backhoe bracket (New Holland
Mount) using one hex flange screw (11) and hex
flange nut (18). See Figure 7.
3. Raise tractor bracket up and attach it to the bot-
tom of the rear axle using ROPS hardware previ-
ously removed.
4. Secure tractor bracket to the back of the rear axle
using two cap screws (7) and hardened flat wash-
ers (14). See Figure 8.
5. Attach tractor bracket to the bottom of the tractor
using two cap screws (8) and hardened flat wash-
ers (14).
6. Install remaining two hex flange screws (11) and
hex flange nuts (18) to the loader mount or back-
hoe bracket.
7. Repeat steps to install left tractor bracket (2).
8. Torque hardware:
M16 x 1.5P x 45 mm . . . . . . 133 lbs-ft. (181 N-m)
M16 x 1.5P x 40 mm . . . . . . 184 lbs-ft. (250 N-m)
5/8 NC x 1-3/4 HFS . . . . . . 170 lbs-ft. (230 (N-m)
Figure 6. Tractor Bracket Installation
Figure 7. Right Tractor Bracket to Loader Mount
Figure 8. Right Tractor Bracket Installed, Rear Axle
1. 1028308 Right tractor bracket
2. 1028309 Left tractor bracket (not shown)
7. 307431 M16 x 1.5P x 45 mm HHCS
8. 1026337 M16 x 1.5P x 40 mm HHCS CL10.9
11. 19024 5/8 NC x 1-3/4 HFS GR5
14. 57817 5/8 Hardened flat washer
18. 1028718 5/8 NC Flange hex nut
†. Tractor hardware
18
11
ROPS
Hardware
DP3
ROPS
Hardware
14
7
14
8
DP4