Woods Equipment 2300003 TV Mount User Manual


 
Hydraulic Installation 11
MAN0572 (Rev. 1/30/2009)
Verify Control Movements
1. Mount loader to tractor: Remove mount pins
from loader uprights. Align tractor with loader and
slowly drive tractor into loader. Shut off tractor.
2. Connect loader feedline hoses to tractor control
valve couplers. See Figure 15.
3. Comply with all safety rules and start the tractor.
4. Mount loader to tractor by activating bucket
cylinders to raise or lower the loader uprights into
the loader mounts. Slowly advance tractor
forward, activating appropriate cylinders to
engage loader completely into mounts. Insert
mounting pins to secure loader.
5. Place feedline hoses between Hose guide and
right loader mount as shown in Figure 17.
6. Check that all tractor hydraulic control lever
positions operate the loader movements correctly.
See Figure 16.
7. If loader movements do not respond correctly,
shut off tractor, relieve pressure, and reconnect
properly. Loader control movements must be
correct before proceeding.
8. Once all loader functions are correct, start the
tractor and operate the loader to check for leaks.
Purge any remaining air from the hydraulic
system and check oil level.
9. Attach the plastic tie straps (included in kit) every
20-inches around the hoses to keep them tightly
bundled and away from contact with the ground
or other moving parts on the tractor or loader.
10. Before operating the loader, make sure that the
Pre-Delivery, Delivery, and Pre-Operation Check
lists in the Loader Operator’s Manual have been
completed.
Figure 16. Single Lever Control Operation
Figure 17. Hose Routing
Handle forward - Boom down
Handle forward to limit - Float position
Handle back - Boom up
Handle right -
Dump bucket or attachment (slow)
Handle right to limit -
Dump bucket or attachment (fast)
Handle to left - Rollback bucket or attachment