Filter
Top Products
6 Mount Installation
MAN0572 (Rev. 1/30/2009)
Install Exhaust Relocation Kit 1024092
ROPS Tractors only
1. Attach exhaust bracket (2) to the right loader
mount using two carriage bolts (4) hardened flat
washers (5), and hex nuts (6).
NOTE: Carriage bolts must be installed so that
the heads are inside the loader mount.
2. Torque carriage bolts to 170 lbs-ft.
3. Attach new exhaust stack (1) to tractor muffler
using hardware previously removed. Do not
tighten at this time.
4. Slide exhaust clamp (3) around exhaust stack.
5. Position stack and clamp against exhaust bracket
(2) and secure using lock nuts provided with
clamp.
6. Tighten exhaust stack hardware at muffler.
1. 1024093 Exhaust stack
2. 1023019 Exhaust bracket
3. 72130 Exhaust clamp 3/8 x 2-1/2
4. 5607 5/8 NC x 1-1/2 Carriage bolt
5. 57817 5/8 Hardened flat washer
6. 230 5/8 NC Hex nut
Figure 6. Exhaust Kit Installation
Figure 7. Exhaust Kit Installed
DP6