Filter
Top Products
4 Mount Installation
MAN0572 (Rev. 1/30/2009)
LOADER MOUNT INSTALLATION
TRACTOR PREPARATION
■ Only use this mounting kit for mounting Woods
LU132 or LU132-2 loader on Case IH
®
JX1085C and
JX1095C or New Holland
®
TN85A, TN95A, TN85DA,
TN95DA tractors. Any other use or modification of
this mounting kit may result in serious injury or
death.
NOTICE
■ This equipment must be assembled and
installed on the customer’s tractor by the Woods
dealer. Dealer must thoroughly inspect equipment
and complete each item on the PRE-DELIVERY
CHECK LIST, DELIVERY CHECK LIST, and PROD-
UCT REGISTRATION from the loader manual
before equipment is released to the customer.
NOTICE
■ Clean threaded holes in the tractor chassis thor-
oughly using a tap of the proper size. Paint, rust, or
debris in the threads may not permit cap screws to
be installed and tightened correctly.
For installing this mounting kit, references to right, left,
forward, and rearward directions are determined from
the operator’s position in the tractor seat.
1. Shut off engine and set parking brake during instal-
lation.
2. Remove the tractor front weights if equipped.
3. Leave mounting hardware loose until loader
mounts are completely installed.
Remove Exhaust Bracket
ROPS Tractors Only
1. Remove exhaust pipe from muffler and exhaust
bracket.
2. Remove exhaust bracket from tractor.
3. Place two washers (7) between heat shield
bracket and tractor. Secure with bolt removed
with exhaust bracket.
NOTE: Washers (7) are included in exhaust relo-
cation kit 1024092.
7. 44546 3/8 Hardened flat washer
Figure 1. Remove Exhaust Bracket
Nord-Lock
®
Washer
The Nord-Lock
®
washer is a unique bolt securing sys-
tem that uses tension rather than friction. When the bolt
and/ or nut is tightened, the teeth grip and seat the mat-
ing surfaces. The wedge locking effect created makes
the bolt self-locking.
The advantage to the Nord-Lock washer is that it
achieves maximum security when locking fasteners.
These washers resist loosening caused by vibration or
dynamic loads. They are easy to install and remove and
provide positive locking at low and high preload levels.
They are reusable if lubricated before reuse.
Figure 2. Nord-Lock Washer
DP5
Exhaust
Bracket
Place Washers (7)
Behind Heat Shield
Nord-Lock
secures bolts in
tapped holes.
Through holes
require two pairs
of NL washers.
Nord-Lock can
not be used on
washers that are
not locked in
place