INSTALLATION 7
MAN0047 (9/15/00)
SUB-FRAME INSTALLATION Cont’d
Sub-Frame Fit-Up
1. Center sub-frame under tractor.
2. Insert cross tube of sub-frame into channel of
rear support as shown in Figure 8.
3. Install clevis pins (1) and hair pins (2) to secure
sub-frame and rear supports as shown in Figure 8.
1. 37827 Clevis pin.75 x 3.14
2. 2688 Hair pin 5/32
Figure 8 Clevis Pins Installed
4. Rotate sub-frame up until locating lugs are posi-
tioned on the outside of front support.
5. Align holes and install bent pin (3) and klik pin 4
as shown in Figure 9.
6. Once sub-frame is secured into position, tighten
all hardware to torque specifications.
7. Remove sub-frame from tractor.
3. 54088 Bent pin
4. 62043 1/4 x 1-3/4 Klik pin
Figure 9 Bent Pin Installation
1
2
3
4
TORQUE SPECIFICATIONS
Wrench
Cap Screw Qty Size Required Torque
M14 x 2.0 x 50mm 10 21mm 80 lbs.-ft.(109 N-m)
M14 x 2.0 x 55mm 6 21mm 80 lbs.-ft.(109 N-m)
M16 x 2.0 x 45mm 4 24mm 125 lbs.-ft.(169 N-m)