Filter
Top Products
Basic Configuration DRS5116
Wren
2003. 09. 06 (v 1.0)
63
14.4. Viewing all Channels with Sequence Mode
- All channels can be viewed in successive order automatically using the [SEQ] button.
- Press the [MENU] button on the front panel to set-up the sequential cycle. (The default value is 3
seconds per channel for display.)
- Select the “Monitor” tab of Configuration menu.
- Move to “Configuration” below “Monitor” using the down arrow button on the HVR-16E front panel.
- Press the [ENTER] button to enter the menu.
- Select “Seq. Switching(sec)” and press the [ENTER] button.
- Set any value between 1 and 60 seconds.
- In order to move to the sequence mode from any viewer mode, press the [SEQ] button.
<Note>
The sequence mode can run only when connected and activated cameras are more than split screen.
With the single full screen mode, there should be two or more activated cameras. With the quad-split
screen mode, there should be five or more activated cameras. With the 9-split screen mode, there
should be ten or more activated cameras. (SEQUENCE MODE ONLY SUPPORTS 4- AND 9- SPLIT
SCREENS). The channel order cannot be changed. For example, with the quad-split screen, Ch.
1/2/3/4 are displayed and then Ch.5/6/7/8 are displayed.
- To end sequence function, press the [SEQ] button