Filter
Top Products
Basic Configuration DRS5116
Wren
2003. 09. 06 (v 1.0)
73
16. Configuration
16.1. Quick Setup
There are three menus for recording setup; Quick Setup, Normal Recording and Alarm Recording
menus in the Configuration Menu. Quick Setup is the easiest set-up,which activates all analog
cameras (4 ~16 Model Dependant) to record with the same settings and conditions. Normal recording
is the standard recording setting and can be customized based on time and channel. Alarm recording
is the recording schedule based on alarm conditions (Motion Detection, Sensors, etc.) Also, Quick
Setup has a time setting menu.
16.1.1. Date/Time
At the time of factory installation, the time zone will be set as “UTC 00:00 Dublin”.
Set the time to the local time zone.
Changing the DRS Digital Recording Solution time may cause time conflict with the recorded images.
In this case, it is strongly recommended to re-format the hard drives after making changes. Care should
be taken to have the correct time programmed prior to rerecording the video. Setting Daylight Savings
time after installation will not affect the recorded images.
<Button control>
- Press the [MENU] button on the DRS front panel.
- Move to the “Quick Setup” menu (the first tab on the Configuration menu).
- Move to “Date/Time” below “Quick Setup” using the downward arrow button on the DRS5116 front
panel.
- Press the [ENTER] button on the DRS front panel.
- Set time (the following picture will be displayed when setting time menu).