Filter
Top Products
23 En
English
Setup Menu
Setting the analog output
Set the analog output to match the
playback capability of this unit.
1 In “AUDIO SETUP PAGE”, press 3 / 4 to
highlight [ANALOG OUTPUT], and then
press 2.
STEREO
Select this to change the channel output to
stereo, which only delivers sound from the
two front speakers.
LT/RT
Select this if this unit is connected to a
Dolby Pro Logic decoder.
2 Press 3
/ 4 to select a setting, and then
press ENTER/OK to confirm your
selection.
Setting the digital output
The [DIGITAL AUDIO] options are:
“DIGITAL OUTPUT” and “LPCM
OUTPUT”.
1 In “AUDIO SETUP PAGE”, press 3
/ 4 to
highlight [DIGITAL AUDIO], and then
press 2.
2 Press 3
/ 4 to highlight an option.
3 Press 2 to enter a submenu.
DIGITAL OUTPUT
Set the digital output according to your
optional audio component connections.
OFF
Select this to turn off the digital output.
ALL
Select this if you have connected the digital
audio output jack to a multi-channel
decoder/receiver.
PCM ONLY
Select this only if your receiver is not
capable of decoding multi-channel audio
signals.
Note:
– If your receiver cannot decode DTS, no
sound output from DTS signals in any
mode.
LPCM OUTPUT
Select this if you have connected this unit
to a PCM-compatible receiver via a digital
terminal, such as the coaxial terminal. In
this case, you may need to adjust “LPCM
OUTPUT”.
Discs are recorded at a certain sampling
rate. The higher the sampling rate, the
better the sound quality.
48KHz
Select this to play back discs recorded at
the sampling rate of 48 kHz. All 96 kHz
PCM data streams (if available) are
converted to the sampling rate of 48 kHz.
96KHz
Select this to play back discs recorded at
the sampling rate of 96 kHz. If the 96 kHz
disc is copy protected, the digital output is
automatically converted to the sampling
rate of 48 kHz.
4 Press 3
/ 4 to select a setting, and then
press ENTER/OK to confirm your
selection.
TIPS: To return to the previous menu, press 1.
To exit from the menu, press SETUP.