Filter
Top Products
Safety Warnings 2
Important Safety Instructions 3 - 4
Table of Contents 5
Step 1. Hook Up the HealthViewTV
TV and other Equipment Hookups
Antenna 6
Cable Service 7
Antenna with VCR 8
Cable service with VCR 9
External Speaker Connection (8-ohm output) 9
Pillow Speaker 10
Step 2. Channel Search and Reception Setup
Auto Program 11
(Select Antenna, or cable service then do
channel search)
Front Panel Controls 12
Optional Installer’s Remote Key Functions 13
On-Screen Menus Overview 14
Step 3. Customize the TV’s Features
Setup Menu (Start with page 11, Auto Program)
15
Setting Add/Del/Blank 16
Clock Set 18
Descriptions of the menus on the TV
Setting On/Off Timers 17
Captions (Caption/Text) 19
Language 21
Video Menu 22
FM Radio Menus 23 - 24
Installer Parental Control Menu 25 - 26
Other Menus and On-Screen Displays 27
Managing the Channel Banks 28 - 30
Installer Menus 31 - 38
LT2000 Quickset II Clone Programmer 39 - 43
Patient Operation Section (Copy for patient usage)
Optional Patient Remote Key Functions 44
Optional Patient Remote
Key Functions - FM Radio 45
Patient Parental Control Menu 46 - 47
Patient Menus and On-Screen Displays 48
Maintenance 49
Troubleshooting 50
Glossary 51
Warranty for HealthView Series TVs Back
Cover
Optional Installer and Patient Remote Controls:
Shown herein are optional remote controls that can be used by the installer and the patient. Be
advise that these remote controls are NOT included with this TV. However, these remotes can be
purchased separately, see your Zenith Electronics dealer.
Installer/Hospital Note:
Pages 44, 45, 46, 47 and 48 contain information and menus which the patient can use to operate the
TV. It is recommended that these four pages be copied and included with the literature packet that the
hospital provides to the patient.
Purchase the Optional Installer’s Remote and Clone Programmer
To perform a normal installation set up, you need an installer’s remote such as the HP602, and the
LT2000 Quickset II Clone Programmer—both are shown and described in later sections. The installer
remote allows access to the Installer menus, User menus, and Source/Channel Bank keys. The installer
remote has Menu, Select, and Adjust, and Channel Bank Keys. The LT2000 Quickset II Clone
Programmer is used to duplicate a TV’s setup and install it on another identical TV.
See your Zenith Dealer.
Design and specifications subject to change without prior notice.
TABLE OF CONTENTS
Page 5
Use the steps outlined below as a setup guide and to determine the TV features
that will require adjustment for the needs of the end user.