3-1
3
Operation
3-1 OPERATOR CONTROLS
The Odyssey 34 lift is equipped with several operator controls; a transmitter mounted in
the cage platform to control the lift; a receiver mounted on the base to monitor and con-
trol the lift; an
ON/OFF switch to turn power on or off; and a laser pointer to help position
the lift before raising the platform.
Receiver
The receiver is located on the back of the base frame and contains four controls, UP and
DOWN pushbuttons, an ENABLE pushbutton, and an EMERGENCY STOP pushbutton. The re-
ceiver also contains LEDs to monitor the operation of the lift and a signal strength indica-
tor to monitor the strength of the signal being sent from the platform transmitter. While
the operator normally does not raise or lower the lift from the receiver, the receiver does
control the operation of the Odyssey 34 lift. When the operator pushes a pushbutton on
the platform transmitter, the transmitter sends a signal to the receiver, the receiver proc-
esses that signal and controls the various lift functions. Refer to Figure 3-1.
Figure 3-1. Receiver
