ODYSSEY 34
3-4
3-2 NORMAL OPERATING PROCEDURE
Perform the following procedures to operate the Odyssey 34 lift.
1. Read and follow all safety precautions contained in Section 1 and all responsi-
bilities outlined in the ANSI A92.3 reprint contained in Section 7 of this manual.
2. Position the lift at the work area. Make sure the lift is on a firm and level surface
and that there are no potential hazards such as overhead obstructions or electri-
cally charged conductors. Do not operate the lift if such hazards exist.
3. Check the lift for damaged or worn parts and repair or replace as necessary.
4. Check to be sure that the cage platform is properly attached to the lift.
5. Pull the four outriggers away from the base. The spring-loaded pin on the jack
should lock in place. If the spring-loaded pin does not lock in, unwind the jack
until the pin snaps in place. Adjust each outrigger so that its footpad is firmly set.
For best performance, assure that the wheels are off the ground.
6. Turn the
ON/OFF switch to ON. Ensure that the E-STOP pushbutton is not engaged.
The controller’s audio program ‘Hal’ will start. Hal will instruct you how to pro-
ceed. Hal will tell you the lift is ready to operate or what outrigger needs to be
adjusted; the corresponding LED will also be lit.
7. Adjust the outriggers until all LEDs are lit. When all outriggers are set properly
and the unit is level, Hal will tell you the lift is ready to operate and the tilt LED
will be off. To enable you to monitor the setting of the outriggers, LEDs for the
corresponding outriggers are located on the sides of the main frame, Figure 3-5.
When the outriggers are set properly the LEDs will be ON.
NOTE: The lift is equipped with a level sensor that will prevent the lift from rais-
ing if the lift is at a slope greater than 1.5 degree. The TILT LED on the
receiver will light and the audio program will tell you that the lift is not
level. Adjust the outriggers until the lift is level and the TILT LED is
OFF.
MAST
MOUNTED
LEDs
Figure 3-5. Outrigger LEDs on Main Frame
