A SERVICE OF

logo

Rev. 3.02
- 44 -
SRP-270
5-10 Main PCB
1. Before you disassembly the Main PCB,
you should remove :
- Plate Bottom (see Chapter 4-2)
- Cover Assy (see Chapter 4-3 & 4-4)
- Case Upper Assy (see Chapter 4-6)
- Printer Assy (see Chapter 4-7 & 4-8)
2. Remove four screws securing the Main PCB.
Separate the Main PCB from the Main Frame.
5-11 Interface Board Assy
1. Before you disassembly the Interface Board Assy, you should remove :
- Plate Bottom (see Chapter 4-2)
- Cover Assy (see Chapter 4-3 & 4-4)
- Case Upper Assy (see Chapter 4-6)
- Printer Assy (see Chapter 4-7& 4-8)
2. Remove two screws and take out the Interface Board Assy, as shown below.