A SERVICE OF

logo

Rev. 3.02
- 77 -
SRP-270
8-8-1-7 Bracket PF “R” Assy
Name of Parts Method and Procedure Drawings
BRACKET P/F “R”
GEAR PF IDLE
GEAR KNOB
GEAR KNOB IDLE
WASHER (1.6*3*0.3)
1. At first, grease the small shaft of
BRACKET P/F “R” with EM -501.
Next, insert GEAR PF IDLE,
GEAR KNOB, and GEAR ③④
KNOB IDLE. Lastly, assemble
WASHER.
2. Grease the outer diameter of gear
with EM-501.
<Check Point>
Check GEAR KNOB to rotate
smoothly.
8-8-1-8 Platen Assy
Name of Parts Method and Procedure Drawings
PLATEN PLATE
TAPE D/F
PLATEN
1. Paste the TAPE D/F onto the
PLATEN PLATE and set the sub
Assy into the rectangular hole of the
exclusive JIG.
2. Set the PLATEN to fit the groove
of JIG and paste by pushing.