C122-E003-02EN 10-23
EFI
10.4 EFI Setup Menu
3 Change the settings.
1) Select the desired item by moving the cursor up, down, left or right.
2) Change the parameter.
3) Press the [Enter] key.
4) Press the [Esc] key to exit from the tool.
4 Save the settings.
If you press the [Esc] key in the [Adapter Properties] or [Device Properties]
window to exit from the tool, the following window appears:
Data Width 16
8
16 Specifies the data transfer
width.
Scan ID Yes
No
Yes Specifies whether to scan the
ID selected at the time of
startup.
Scan LUNs >0 Yes
No
Yes Specifies whether to scan
LUNs greater than 0.
Disconnect Off
On
Off Specifies whether to permit
SCSI operation disconnection.
SCSI Timeout 0-255 10 Specifies the SCSI operation
timeout value.
Queue Tags On
Off
On Specifies whether to permit use
of queue tags.
Format Formats the selected device at
low level. (This item is only
available when the device is a
hard disk drive.)
Verify Verifies every sector of the
selected device and, if any
defective sector is found,
performs reassignment. (This
item is only available when the
device is a hard disk drive.)
Restore Defaults Pressing the [Enter] key resets
the items to their defaults.
Item Parameters Default Description
