List of Figures
FIGURE 1 - HyperTerminal screen showing the serial settings.................................................................24
FIGURE 2 - Prompt indicating the switch model number as well as mode of operation – note the
commands to switch between the levels is not shown here..............................................................25
F
IGURE 3 - Setting IP address on the switch.........................................................................................26
FIGURE 4 - Rebooting the switch ..........................................................................................................27
F
IGURE 5 - Viewing the basic setup parameters. You can use ‘show setup’ or ‘show sysconfig’ to
view setup parameters ................................................................................................................27
FIGURE 6 - Switching users and privilege levels. Note the prompt changes with the new privilege
level. .........................................................................................................................................28
FIGURE 7 - Adding a user with Manager level privilege .......................................................................29
FIGURE 8 - Deleting a user .................................................................................................................29
FIGURE 9 - Changing the password for a specific user...........................................................................29
FIGURE 10 - Changing the privilege levels for a user.............................................................................30
FIGURE 11 – Creating user access privileges...........................................................................................30
FIGURE 12 - Help command..............................................................................................................31
FIGURE 13 - Help for a specific command...........................................................................................31
F
IGURE 14 - Options for the ‘show’ command......................................................................................32
FIGURE 15 - Listing commands available (at the operator level) ...........................................................32
FIGURE 16 - Listing commands starting with a specific character..........................................................32
F
IGURE 17 - Listing commands options – note the command was not completed and the TAB
key completed the command. ......................................................................................................33
FIGURE 18 – logout command ..............................................................................................................33
FIGURE 19 - Checking the IP settings..................................................................................................36
FIGURE 20 - Changing the boot mode of the switch ..............................................................................38
FIGURE 21 - Changing telnet access – note in this case, the enable command was repeated without
any effect to the switch................................................................................................................38
FIGURE 22 - Reviewing the console parameters – note telnet is enabled .................................................39
FIGURE 23 - Example of a telnet session.............................................................................................39
FIGURE 24 – managing and viewing multiple telnet sessions ..................................................................40
xi
